Ian Posted May 23, 2011 Report Share Posted May 23, 2011 I have a new CTLS, so far about 40+ hours on it - last week, the EFIS started behaving very oddly - the pitot derived information was fine, but on the D100 display, the attitude indicator toppled and the DI just goes round in circles! Any ideas? Link to comment Share on other sites More sharing options...
Roger Lee Posted May 24, 2011 Report Share Posted May 24, 2011 Hi Ian, You can try a new 5.4 download update in case you have a corrupted file, but if that doesn't work sounds like the D100 will have to go back to Dynon. It could be a bad sensor. p.s. Make sure something on the back like a wire did not get broken or pulled out. Link to comment Share on other sites More sharing options...
NC Bill Posted May 25, 2011 Report Share Posted May 25, 2011 I had a similar screen image with my Skyviews. Turned out the ADAHRS had gone TU and had to be replaced. Suggest you call Tech Supp at DYNON (425) 402-0433 to trouble shoot it. Link to comment Share on other sites More sharing options...
Roger Lee Posted May 25, 2011 Report Share Posted May 25, 2011 He has talked to Dynon and I believe he's sending it back. Link to comment Share on other sites More sharing options...
Ian Posted May 25, 2011 Author Report Share Posted May 25, 2011 Thanks for the replies - by some good fortune there were two guys from Flight Design over in the UK this week, one test pilot from Germany and one electronics guy from Ukraine so it was arranged for them to take a look - that's where the good fortune ends as they both agreed that the fault was in the Dynon unit (the accelerometer is indicating -5.8 g which is upsetting things just a bit) and it will have to be a replacement - still good to get a diagnosis. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.