Jump to content

"remote compass not detected"


art Stark

Recommended Posts

Occasionally I’ll be flying along in my CTLS when "remote compass not detected" appears on my Dynon, Will this affect my 496 or my Auto Pilot?

Roger tells me it is a wing problem and to check the line/plug when wings are removed. . Anyone know about this?

Link to comment
Share on other sites

Hi art,

 

Remember to update the 2008 D100 software first. Then check the serial connector in the left wing, through the clear plastic inspection port, that attaches to the remote to see if it is snug. The one place I didn't tell you about was where the wing wires plug into the fuselage wires. There is a plastic connector above your head where the aileron bracket attaches to the control rod. Just fish it out. I found a broken wire here once. This is a high probability area. The last place is the D100 itself for a bad wire. Look in the D100 installation manual and it will tell you which pin and color wire.

My money is on the plastic connector or the software, but the software needs to be done first.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...