procharger Posted March 8, 2016 Report Share Posted March 8, 2016 On number 2 cylinder do o rings go on front studs? Anyone know why the torque was changed to 120 verses 180? Link to comment Share on other sites More sharing options...
Tom Baker Posted March 8, 2016 Report Share Posted March 8, 2016 http://legacy.rotaxowner.com/si_tb_info/serviceinfo/si-912i-006r1.pdf Link to comment Share on other sites More sharing options...
Roger Lee Posted March 8, 2016 Report Share Posted March 8, 2016 Good post Tom. p.s. Studs are only screwed in finger tight. If you crank them down you may crack the case. Link to comment Share on other sites More sharing options...
Tom Baker Posted March 8, 2016 Report Share Posted March 8, 2016 Good post Tom. p.s. Studs are only screwed in finger tight. If you crank them down you may crack the case. Actually there is a torque spec for the studs, but it is ridiculously low. (27 in/lb.). Link to comment Share on other sites More sharing options...
Roger Lee Posted March 8, 2016 Report Share Posted March 8, 2016 We teach finger tight in school. That may be close to 27 in/lbs. Link to comment Share on other sites More sharing options...
Tom Baker Posted March 8, 2016 Report Share Posted March 8, 2016 All I know that is what the SB called for, and that is what I did. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.