Roger Lee Posted February 11, 2017 Report Share Posted February 11, 2017 Just for fun. https://youtu.be/gnBOBIwNsUY Link to comment Share on other sites More sharing options...
Runtoeat Posted February 12, 2017 Report Share Posted February 12, 2017 Thanks Roger. Link to comment Share on other sites More sharing options...
Tom Baker Posted February 12, 2017 Report Share Posted February 12, 2017 When you are performing this measurement, make sure to use a ruler that the measure goes all the way to th end. Unlike the ruler Roger used in the video. Link to comment Share on other sites More sharing options...
FlyingMonkey Posted February 12, 2017 Report Share Posted February 12, 2017 I made a "float gauge" from a piece of aluminum angle, with a line at 10.5mm. I can lay the flat bottom against the carb and see if the lever arms are right at the line or not. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.